Page 1 of 1

Gear leg fillet

Posted: Sun Oct 17, 2021 5:24 pm
by Joe Moilanen
Not that it would be hard to make one, but I was curious if anyone knew of a source for the rubber landing gear "fillet" (P/N 0511125) that seals off the gear leg where it exits the fuselage? TIA!

Joe
4518C

Re: Gear leg fillet

Posted: Sun Oct 17, 2021 7:03 pm
by Metal Master
Hi joe,
I mentioned your name to Wayne out at Thun last week.
I use cut out pieces of innertube.
Regards,
Jim

Re: Gear leg fillet

Posted: Sun Oct 17, 2021 8:17 pm
by dstates

Re: Gear leg fillet

Posted: Sun Oct 17, 2021 9:28 pm
by Joe Moilanen
Metal Master wrote:Hi joe,
I mentioned your name to Wayne out at Thun last week.
I use cut out pieces of innertube.
Regards,
Jim
Thanks Jim, that's probably what I'll do.

Joe